Step 1:
Fully extend slide and locate black lever as shown in Figures A and B. Depress Lever, this will unlock slide from shelf.

FIGURE A	FIGURE B

Step 2:
Align slides inside cabinet as shown in Figure C. If mounting door on front of trash bin, move slide forward as shown in Figure D.

FIGURE C	FIGURE D

Step 3:
Measure distance of slide from side of cabinet as shown in Figure E. Move rear of slide (Figure F) and position it the same distance from side of cabinet using measurement taken in Step 2

FIGURE E	FIGURE F

Step 4:
Secure slide to bottom of cabinet using #6 screws as shown in Figures I and J. Make sure to use slotted holes in mounting plate, this will allow you to move slide left or right as needed for final fit.

FIGURE I	FIGURE J

Step 5:
Measure distance between front of slides (Figure G). Then check to make sure rear of slides measure the same distance (Figure H) as front and secure to bottom in same manner explained in Step 4

FIGURE G	FIGURE H

Step 6:
Align drawer and slides making sure to push drawer completely in so slides lock and are fully engaged. Check fit by moving drawer in and out, it should slide freely. If slides or too close or two far apart, drawer will drag and bind. After proper fit is acquired, remove drawer and insert #6 screw into center round hole on bracket. This will prevent brackets from moving out of position.